
Standard Resin:
● High Precision & Fast Printing
● Strong Adhesion & Easy to Detach
● Stable Performance & Various Colors
Tough Resin 2.0:
● Exceptional Toughness & Resistant to Breakage
● Strong Elongation & High Flexibility
● High Precision, Minimal Shrinkage
High Speed Resin 2.0:
● High-Activity, Low-Viscosity, Low-Time-Consumption
● Less Prone to Failures and Damages
● Robust Models, Retaining Textures
● Less Odor, More Reliability
DLP Craftsman Resin:
● Developed for DLP 3D Printer
● Photosensitive resin + NanoCeramic
● Fast Speed, Low Shrinkage
- Shake the liquid resin before use.
- Clean the resin tank and the molding platform to keep the bottom of the resin tank in lighttransmission.
- Unscrew the cap and add it to the resin tank according to the equipment requirements.
- Select the correct print parameters and settings for printing.
- After printing, please use the matching tools for post-processing, including blade, diagonalpliers, tweezers, containers, gloves.
- ethanol(≥95%), lactate or isopropyl alcohol cleaning solution.
- A. Remove the printed model from the molding platform with a blade.
- B. Submerge the model in the cleaning solution, rinsed or ultrasonically washed, then takenout and drained; ANYCUBlC Wash and Cure machines are suggested to ensure better effect.
- C. Proper processing, such as removing support, polishing, coloring, etc.
- The ideal condition for storing uncured resin is a cool, dark place at room temperature and protect from light to avoid high temperature or sunlight.
- Suggested operating temperature is 18-35'c, and a low temperature may affect the printing effect, thus, the resin can be properly preheated before use (not more than 60°C).
- If the resin pigment settles, it can be used after stirring or shaking.
- In order to ensure the performance of the resin, please take out the model in time after cleaning to avoid the model soaking in water for a long time.
- To ensure the mechanical properties of the model, please perform post-curing in time after cleaning and drying.
- To ensure the ideal performance of the curable material, it is necessary to control the intensity and time of the light source after curing. Therefore, the following steps are recommended:
- 1. The intensity of mercury lamp or LeD light source is 5-10mW/m?, and the duration is no more than 1 hour (self-regulation)
- 2. The exposure time in the sun (summer) is around 1 hour
- 3. Proximity or long-term exposure under strong light sources such as high-power high-pressure mercury lamps is prohibited
- 4. lt is recommended to print in a dark room or be covered with a lid while printing as resin is a photosensitive material.